1000W Motor suit Unicool VDM-10: Dragon Raptor, Apollo Ghost etc
UNICOOL-VDM-MOTOR
AU$299.09
Replacement hub motor
In stock
1
Product Details
Brand:Unicool by eScootNow
52 volt 1000 watt factory original motor suits front or rear VDM-10 such as ODM of Dragon (Raptor, both non-Pro and Pro variants), Bolzzen (Dynamo/Gladiator 5218), Apollo Ghost, Carbon Oxy & e-Glide Mach 10 and other ODM's.
Will also suit other models according to dimension.
Has motor hall sensors (for sine wave controllers) with crimped connectors on the controller end of the hall wires. These are not used in non-Sinewave controllers.
Cable length 1 meter.
Adopts 10mm depth on the rim cover bolt rather than 6.5mm.
Order 2PCS for front and rear. Includes motor hall sensor connector housing, six socket head M5 20mm rim bolts (for the included rim usually the 10mm type), two axil nuts, two hook washers and two (or four) flat washers.
12mm axil thread with 10mm key. Length between the inner washers is ~132mm. Overall length of axil shaft ~192mm.
Typically required when original motor has failed and/or motor cable damaged beyond feasible repair. These motors are pushed to limits, being "1000 watt" nominal nameplate rated, which is probably on the higher-end of physical design. At full throttle on most makes/models, these motors are driven at 1300 watts which sustained over period of time can result in pre-mature failure (excessive heat, prematurely fail bearings or adhesion on plates). eScootNow recommends to always ride in dual motor to spread load across the entire system.
Notes:
eScootNow also stocks the rim as separate item.
Alternative stockists on ebay and AliExpress has a few listings, Bike Scooter City Sumner Park or possibly Bolzzen would also have local stocks.
Pre-2022 apollo ghost models had 800w nameplate marking on their motors, that motor can be renewed with the 1000w nameplate version.
Often in appropriately marketed as "1600 watts peak". At 52V on a 25a controller these would peak near 1300w, 1470w at 58.8v (which never happens).