Throttle/display suit Kaabo Mantis 8/10 Pro , Wolf Warrior 11 Pro+ (60V 35Ah), King + (72V 28Ah) and X Pro+ (60V 28Ah). These variants adopt the Kaabo MiniMotors Square Wave controller.
Will usually suit any make/model that adopts the MiniMotors signalling system, easily identified by presence of MiniMotors EY3 branded display, although branding may differ such as the Bolzzen TNE models and likely those of Blade (Teverun). The presence of a M8 black 6-pin plug also informs likelyhood of compatability.
Typically required to replace physical damaged original throttle/display.
Wired for plug-and-play installation. Includes bracket.
Genuine Kaabo factory spare.
Notes:
For Mantis Pro, SE and Elite models, use LT01 throttle/display.
Check P-Settings for appropriate voltage 48/60V/72V, magnets, wheel size etc. Includes clamp bracket unless option chosen not to include.
This is a Kaabo factory spare and fitted with black M8 6-pin male plug for plug-and-play in Kaabo makes. The last few product photo's reveal the inside where the cable terminates. For Dualtron models (such as Ultra, Thunder, Eagle, Victor, Storm, X2) note Dualtron stock throttles have a wire extending out of a gromit on the back of the display/throttle to the controller in the deck. Dualtron typically has no M8 plug on the main line unlike that adopted by Kaabo. Inside the back of the enclosure note the flat white JST connector on the PCB, to re-terminate existing Dualtron line. eSN does not stock Dualtron cables, but we do stock cables with the M8 black 6-pin plugs if looking to repair existing dualtron cable.
MiniMotors released a newer version of EY3 as shown below, however these are not suitable for use on Kaabo models. The "newer" type has different wiring to that of Kaabo and they have a reputation for poor reliability (and dead on arrival failures).