Kaabo MiniMotors EY3 Finger Throttle/Display suit Mantis and Wolf Warrior

• Throttle/display suit Kaabo Mantis 8/10 Pro , Wolf Warrior 11 Pro+ (60V 35Ah), King + (72V 28Ah) and X Pro+ (60V 28Ah). These variants adopt the Kaabo MiniMotors Square Wave controller.
• Typically required to replace physical damaged original throttle/display.
• Wired for plug-and-play installation. Includes bracket.
• Genuine Kaabo factory spare.

Notes:

1. For Mantis Pro, SE and Elite models, use LT01 throttle/display.
2. Check P-Settings for appropriate voltage 48/60V/72V, magnets, wheel size etc. Includes clamp bracket unless option chosen not to include.
3. Refer to Kaabo Spares Category Home Page for wiring diagrams.
4. This is a Kaabo factory spare and fitted with black M8 6-pin male plug for plug-and-play in Kaabo makes. For use in Dualtron models, open the back of the display and note the flat white JST connector on the PCB. For compatibility with Dualtron, you would connect via that white JST connector and discard the supplied (pre-fitted) black M8 6-pin connector and lead.