Shimano B01S/M315 Brake Pad

• The "Shimano B01S/M315" pad is a commonly used pad on eScooters with:

• Logan 2-piston callipers which are stock callipers on NAMI models of:
  • Klima and Stellar (it is assumed the cable brake version Stellar also use this pad).
  • Late model (post-NUTT) Burn-e 2 Non-Max (28Ah). Models such as 2 Max 32/40Ah use Logan 4-piston pads and earlier non-Max use NUTT pads.
• XOD H800/880 callipers:
  • The black Dragon branded calliper on early model Dragon Cyclone Pro. Newer Cyclone models have a yellow calliper that uses a hook pad (TurboBrake HB427-H calliper).
  • Some Blade (GT) and Mercane (G3 Pro) models.

Logan (NAMI) and Dragon Branded XOD callipers shown below:

• Available in four compounds. To further understand merits of each compound, refer to the Brake Pads Category homepage
• Supplied as a set (pair) two pads, one for each side. Order two sets for both front and rear. Retaining spring and pin included.

Notes:

1. This pad is too large for the NUTT A5-D calliper. For A5-D, use cooling enhanced finned pad or Crown pad.
2. These pads are adopted from the 30.5mm wide Shimano B01S, B03S & B05S pads and subsequent M315/355/395/416/455/446/447/446/455 series. eSN designates this pad as B01S/M315 to reflect the inaugural Shimano designations.
3. These pads can be cut down to size to reduce width as an alternative-compound to the resin semi-metal compound Zoom pads, with varying degrees of success.
4. This pad is slightly wider than the YD-01 NUTT cooling enhanced pad and will not fit in the NUTT A5-D calliper.
5. Appears visually similar to the Zoom pads but wider, will will not fit in the Zoom hydraulic calliper which typically requires a pad no wider than 30.1mm.
6. Guide to NAMI Burn-e Series pads by Steven Chan
   Showing YD-01 pad (Burn-e / early Burn-e 2 non-Max, NUTT calliper) and the Logan calliper pads on on later model Burn-e 2 (non-Max) Shimano B10S/M315 pads and Burn-e 2 Max Logan 4-piston pads.