Kaabo Wolf Warrior 11/X/GT/GTR Headlight

• Kaabo factory original headlight for Wolf Warrior Series including Wolf Warrior 11, Wolf Warrior 11 King, Wolf Warrior X and Wolf Warrior GT Series.
• Plug-and-play fitted as replacement, and for the GT also plug-and-play as a second (additional) headlight.
• Considered great value bang per buck on price vs lumens output. One of the best stock factory headlights adopted amongst eScooter manufacturers with a reasonable throw to around 15-20 degrees and reasonable colour. Throw is not significantly long and has with some unwanted spill.
• Marketed voltage range support 12-80 volts. Current draw observed by eSN cold (different meters used in 12V vs 83V tests):
  • 12V: High 1.8A (21.6 watts), Low: 0.44A (5.3 watts).
  • 83V: High 0.31 (25.0 watts), Low: 0.09A (7.4 watts).
• 4 state stateful UI: High, Low, Flicker, Off.
  • State transitions are triggered via input power cycle.
  • The Flicker and Off sequence isn't ideal for quick low/high beam switching, especially with latching type switch mechanism on the stock switch which requires 6 presses to cycle all modes.
• Available as 11 (including King) or GT spare. Both have wires fitted with two crimped JST SM pins on the conductors and black plastic housing to form the 2-pin JST SM plug:
  • The 11 spare is fitted with 1.1m cable which extends to the deck to connect to the controller:
  • The GT spare is fitted with 35cm cable which extends to the wire collection board in the Electric Controller Box (ECB).
    • An optional prepared conversion lead Black 2-pin JST SM receptacle to White 2-pin XH plug plug and play's to the wire collection board if needed. Shown below bottom left.

For Wolf Warrior X plug-and-play, you want the longer 11 spare and likely (if not already fitted) the optional prepared conversion lead (Black 2-pin JST SM receptacle to White 2-pin XH plug) to connect to wire collection board.

If intending to connect the headlight in conjunction (concurrently) with the existing one to run two/dual headlights, note the wire collection board has two light outputs designated on black / white diagrams/labels as 10/7 Head Light and 14/8 native system voltage. As the headlight supports 12-80V, you can use either, with the high voltage preferred to reduce loss given current. Note as fixtures are stateful, the transitions could go out of sync between two headlights due to tolerance and switching.

For NAMI plug-and-play, the shorter GT spare with M8-JST Conversion Cable [TurboTap] shown below bottom right.

• The mounting hole accommodates an M6 bolt (it is not threaded). Optional brackets available:

• Wide bracket: Suits Wolf Warrior 11, 11 King and X series. Bracket attaches to outside of fixture mounting point.
• Narrow bracket: Suits Wolf Warrior GT series (including King GT) and Wolf King GTR. Bracket attaches to inside of fixture mounting point for stem controller box.
  
  Both brackets include bolts to fix the light to the bracket (2 x Socket Head Bolt M6x16mm, lock washer and M5 lock nut).
• Fixture weight: 265 grams.
• Genuine Kaabo factory spare.
• Refer to Kaabo Spares Category Home Page for wiring diagrams.