NAMI Light and Horn Switch (suit Burn-e, Klima, Stellar and Blast)

• "Light and Horn Switch" (switching instrumentation) suit NAMI Electric (all models Burn-e, Klima, Stellar and Blast).
• Typically required when replacement is needed from physical damage (such as bent plug pin) or horn / light switch mechanism failure (arcing over time particularly on the horn, especially when owners fit upgraded heavier horns and headlights, may prematurely fail the mechanism). Wired for plug-and-play installation.
• Genuine NAMI Factory Spare (nami-electric.com product URL)

Notes:

1. eSN also supplies a TurboTap switch for NAMI with rocker/slider turn signal mechanism.
   
2. Very early models (early 2023 and prior) had a green 5-pin plug where the status LED's adjacent to the buttons did not operate. An additional (6th) pin was subsequently introduced on the 6-pin black plug, with the additional conductor being in the center. The 6th pin supplies +ve (native system voltage) to the switch to enable status LED's to function as switching is a negative switched design. The main cable with the inaugural 5-pin plug "V0" is discontinued, with all subsequent cables being 6-pin. Extract below shows the 6th (white) wire on BAMING diagram from the reference materials page. All switches are now supplied with 6-pin black female connector.
   • 6-pin switches are backward compatible with 5-pin "V0" main cable. If you have an older "V0" main cable with 5-pin green male connector, the 6-pin switch will operate, without status LED's.
   • Older 5-pin switches will not natively support 6-pin "V1 and above" main cable. Options are 1) bore a hole in the centre of the switch connector, 2) remove the centre pin from the main cable (when disconnected from lower main cable) or 3) replace the switch with newer 6-pin type.